Upgraded Pump: sPlant Big Power Automatic Drip Irrigation Kit for 15 Potted Plants

Don't worry anymore! When you're away from home, the automatic watering system can take care of your plants, allowing you to rest assured while working or traveling. This automatic watering device is the best solution for caring for your plants when you're on holiday or at work.

Using an automatic waterer to regularly water your plants can effectively extend their lifespan and help them grow lush and healthy. Here's how the watering unit helps care for your plants:

✓ Automatic watering with customizable cycles ✓ Digital panel with simple three-button controls for easy setting ✓ Includes all-in-one accessories for easy 4-step setup ✓ Supports both AA battery and direct USB charging ✓ Saves 70% more water than traditional sprinklers ✓ Settings are stored in internal memory automatically

Your plants will never be neglected again!

To set up the system:

1. Design your loop: Draw a design map to determine where the T-connectors will be used, helping you cut the soft pipe efficiently and prevent waste. (Ensure the water bucket is placed lower than the pump to avoid siphonage and dirt contamination.)

2. Outlet Pipe: Measure the distance between your plant pot and the watering device, then tailor the pipe to that length. Insert a dripper at one end of the tube and install it to the pump.

3. Inlet Pipe: Measure the distance between the water source and the device, then cut the pipe to that length. Insert a filter at one end of the pipe and install it to the pump.

4. Power Supply: Insert 4 AA batteries or connect the 5V USB cable to power the device.

Water Timer Setting:

1. Wake Up: Press any button to wake up the indoor drip irrigation kit.
2. Watering Time: Press the left button to set the watering duration (5-55 seconds or 1-30 minutes).
3. Watering Interval: Press the right button to set the watering interval (1-30 days or 1-23 hours).
4. Unit Switch: Long-press the left or right button to quickly cycle through the units.
5. Confirm Setting: Press the middle button to confirm and enter the first automatic watering mode.
6. Manual Watering: Press the middle button to start or stop the pump. If the "watering time" is set, the device will stop when the time is up.
7. Attention: To ensure the desired water flow, test the "watering time" in manual mode. The number of drippers or plant height can affect the flow rate.

Troubleshooting:

1. Weak or Overdosing Water Flow:
2. Avoid siphonage: Keep the water source/bucket lower than the pump.
3. Use more than 4 drippers for optimal pump life.
4. Avoid using a cross joint (4-way) with multiple drippers.
5. Clean the filter weekly.
6. Keep the inlet pipe under 9.8ft, ideally 3.2-6.5ft.
7. Keep plants under 6.5ft from the water source.
8. Limit the outlet pipe to 33ft.
9. Ensure proper dripper connections to prevent leaks.

10. Soak the tube (especially the dripper connections) in hot water for a tighter fit.

11. Device Not Working:

12. Check for tube bends or clogs.
13. Verify the battery level or use the USB power supply.

14. Ensure the timer is set correctly.

15. Dripper Flow Rate:

16. The voltage-regulated drippers provide a steady flow.
17. With a high-power pump, we recommend 4+ drippers.
18. Average flow rates: 4 drippers - 60-80ml/min, 6 drippers - 60-70ml/min, 8 drippers - 50-70ml/min, and so on.
19. Adjust the number of drippers based on your plant needs.
20. Replace any abnormal drippers or hoses.

product information: